Monday, August 27, 2012

Air Nail Machine Working Principle and Adjustment Method

The working principles for steel air nail machines:

The steel air nail machine makes the steel nail placed on the top of the hopper to move by means of the motor vibration force, the "T" shaped head of some air nails falls below the hopper at the bottom, nail tip automatic sagging under its own weight, so as to arrange a lot of nails in the open hopper tank. Nail making machine hopper can display a certain angle and horizontal line to make the nails roll under shock and vibration, to prevent their agglomeration and block materials. The utility and new air nail machine is applicable in the mechanization of the "T"-shaped nail.

Structure of steel air nail machine

The steel air nail machine described above includes motor, upper vibration plate, lower vibrating plate, guide posts, punch, materials, fuel tank and trough plate; The motor is connected through the component and the lower vibrating plate is slipset under four guide pillars, the upper vibration plate is set on shoulders in the four guide columns, the head is mounted in the lower end of the vibrating plate; hopper bottom plate is connected to the vibration plate through the bearing housing, base plate and fuel tank are connected, the fuel tank tilt at an angle around the fulcrum; hopper is fixed on the floor of the four pillars, the sleeve in the four pillars has trough plate, which is driven to move up and down by the cylinder; the hopper opens a slot in the middle at the bottom, whose width is slightly wider than the pneumatic nails and staples diameter; there are a number of teeth on both sides of the groove, the tooth width and tooth depth are slightly wider than the nail head; the middle of the trough plate has a gap which is slightly wider than the air nail diameter.

How to adjust air nails machine device?

1. Pressure Adjustment: Adjustment the air pressure to be 5.5-6kg. 2. Air nail feeder adjustment: Loosen and tighten the bolts, the nail making machine adjusts the long and short screws, lock and tighten the bolts after adjustment, feeding electric eye is the light on when the feeding is and light will be off because there is no material after feeding. 3. Air nail Cylinder adjustment (1) Place the cylinder in a returned position and observe whether the material thimble is just at 3 page of the mold push trough. It must be adjusted to be within the 5mm-10mm scope. (2) After fixing and adjusting the discharge cylinder thimble, carry out optical adjustment. When adjusting two photoelectric of forward stop and backward stop, the air nail cylinder is in before and after bits, slowly move the photoelectric and electric eye until the photoelectric switch lights on, fix the electric eye. (3) Cylinder return electric eye stops the lights until the cylinder back to the bit. Cylinder forward electric eye stops lights until the cylinder into the bit. For more information about air nails, please feel free to visit: www.air-nail-staple.com

This article is come from: http://www.power-supplier.info/5050-smd-strip/air-nail-machine-working-principle-and-adjustment-method.htm

No comments:

Post a Comment